|
History
Although this used CMM was
previously owned, it has been completely
over-hauled at the Helmel factory. Our
rebuild program installed new
non-contact linear scales, new
DCC electronics, motion controller and
joystick plus
the latest computer system with Geomet
software. This CMM has been
completely inspected and
calibrated at the Factory. This
PcMM is built on a substantial
granite base for dimensional and thermal
stability. All ways, bearings, scales and
motors have been thoroughly tested to
the same standard our new CMMs receive. The
PcMM
employs non-contact steel scales and
steel members for uniform thermal
behavior. Its drive system is based on
non-contact linear motors for efficient
and wear-free operation. The design emphasizes powerful
bearing ratios together with Helmel's
tradition of precision mechanical
bearing movement on hardened and ground
ways. Our straight and square
construction insures intrinsic
mechanical accuracy without reliance on
volumetric error correcting software
tricks. This makes calibrations simple
and saves you money in the future. Just
add a Renishaw Touch Probe and it is
ready for inspection.
Would you like more
information?
Please use our information
request form. |
